Turn Device On and Off
Learn how to turn your device on and off.
Moasure supports two turn-on methods. A legacy Double-Tap method that requires a double tap on your Moasure device to turn on and a new Rotate method that enables turning on the device by holding it vertically and rotating it 180 degrees and back. The rotate-to-turn-on feature is only available on firmware versions from v1.28 upwards. The firmware update is being rolled out to users globally. Once it's available to you, you will receive a notification through the Moasure app, asking you to upgrade. If you would like early access to this feature, please contact us by emailing support@moasure.com.
Turn on Moasure by Double Tapping
To turn on your Moasure device, simply follow these steps:
Place your device in the palm of your hand
Using your fingertip, double-tap the face of the device to turn it on
If you double tap your Moasure device too fast or too slow, you may find that it doesn't turn on. Take your time and practice – adjust the speed and force of your taps.
Turn off Moasure
By default, your Moasure device automatically switches itself off after 60 seconds of inactivity. However, you can adjust the device's disconnection time by following these steps:
Go to Settings within the Moasure app (tap the cog in the top-right corner of the app)
Tap on Measuring Options
Scroll down until you see Moasure Device Disconnection where you will be able to set how long you would like the Moasure device to stay awake. You can choose from 30 seconds, 1 minute, 2 minutes and 5 minutes
Double-Tap Sensitivity
If you would like to change your Moasure double-tap sensitivity, please follow these steps:
Go to Settings within the Moasure app (tap the cog in the top-right corner of the app)
Go to Account & Device Management and tap on Select Device
Tap the Information icon for your listed device
Turn on your Moasure device so that your Moasure app can make a connection
Tap on Double-Tap Sensitivity and choose between the following settings; Low (harder tap), Medium, High (softer tap)
Turn on Moasure when using Moasure STICK
When using Moasure STICK, you can turn on Moasure without removing the device from the foam-lined enclosure:
Place the STICK down on a solid, flat surface
Double tap the sharp edge of Moasure (where the LED indicator is located)
Turn on Moasure by Rotating
To turn on your Moasure device, simply follow these steps:
Pick up your Moasure device and hold it up in vertical orientation
Rotate it 180° to the right
Rotate it 180° to the left
The device will turn on
Last updated
