Firmware Update for Moasure ONE

This page outlines the steps required to update your Moasure ONE's firmware using the Moasure Updater software for Windows or MAC


Download Moasure Updater Software

Click to download the Moasure Updater for Windows


Windows 10

Important: Please extract the entire folder including all 4 files before running the Moasure Updater

Click to download the Moasure Updater for macOS


macOS (10.10 and above)

Instructions for Windows

 

1. Plug your Moasure ONE into your PC/Laptop's USB port with the supplied microUSB cable.

2. Wait roughly 30 seconds whilst your computer recognizes your device.

Note: Windows may start to ‘setup your device’. If so, please wait for this to fully complete before starting the “Moasure Updater” Software

3. Download the "Moasure Updater" Software.

Note: You may see a pop up from Windows Defender. If so, please click 'More Info' and then 'Run Anyway'.  

4. Unzip the files.

5. Run "Moasure Updater.exe".

Moasure Updater will start immediately updating your Moasure ONE.

Once you see the following screen with the "Moasure Device Updated – please Unplug your Module" message. Please unplug your Moasure ONE and close the application.

8. Congratulations, you are now ready to get "Moasuring" again.

Any issues, please don't hesitate to contact us, via the Moasure App.

Instructions for Mac


1. Download the "Moasure Updater" Software.

2. Please click "Open" when you get a warning regarding downloading the "Moasure Updater" application from the internet

3. Run "Moasure Updater.app".

4. You will see a screen waiting for you to connect your Moasure ONE with the supplied microUSB cable.

5. Click "Start"

6. It should only approximately 20 seconds to update. Once done, close the application and unplug your Moasure ONE.

7. Congratulations, you are now ready to get "Moasuring" again.


Any issues, please don't hesitate to contact us, via the Moasure App.